The GE4030 enables rapid measurement of ash content and determination of the calorific value of coal samples taken directly in the operating premises or laboratories. This makes it possible to adopt operational solutions and decisions and thus make a significant contribution to the efficiency of operations and consequently also the reduction of economic costs.
The GE 4030 coal fast-analyzer enables fast analysis of non-combustible content and calorific value of coal samples immediately on site or in the laboratory. Operational evaluation of coal quality can significantly raise processing efficiency and consequently also keep running costs lower.
Technical data
Weight of the measured sample
approx. 3.5 kg
The granularity of the measured sample
up to 20 mm
Measurement range
adjustable according to requirements
Measurement accuracy
better than ± 0,5%
Measurement time (reaction)
3—10 min
Power
180—260V, AC, 40—60 Hz
Protection
IP54
Sample container size
191 × 123 × 130 mm
Dimension of the device
800 × 850 × 600 mm
Weight
75 kg
Coal stands for one of the most important energy sources. The need of saving all kinds of energy is strongly emphasized nowadays and though the coal mining and efficient processing becomes the firstdegree interest. The need of immediate coal quality evaluation or evaluation in reasonably short time results from the requirements of combustion and mining process optimization.
Show more
GE4030 is intended for fast measurement of ash content and calorific value of fuel samples. The unit is produced as desktop unit, the whole measurement is performed with no user manipulation with samples in the radiation beam. After putting the sample into the measurement container and closing the cover, the sample is moved to the measurement radiation beam. The measurement is performed automatically. After finishing the measurement, the sample is automatically moved out of the radiation beam for user manipulation. The complete information on the measurement process is displayed on the touchscreen user interface panel with possibility of data transfer to the supervisory system. System setup and calibration can be also performed using the user interface panel in a simple and user-friendly way.
Show more
The measurement method evaluates the coal non-combustible content according to differences of attenuation of two gamma beams of different energy passing through the coal. While
the changes in chemical composition in the ash content are low, there's a significant correlation between the ash content and the average proton number. The measurement beam is passing through coal sample while the resulting radiation is evaluated by detector with control unit. Based on the retrieved attenuation values of radiation beams the control unit can compute the ash content and calorific values.
Would you like to find out more about the products? Contact us by e-mail or phone. We will arrange a meeting to present our ENELEX product portfolio in detail.
